![]() ![]() ![]() TABLES 2 (see page 28) AND TABLE 3 (see page 30) (GATE END POINTS ARE NOT AFFECTED).ġ.1 Battery low condition (Status flashing 3 times)ġ.1.1 Old battery 1.1.2 Check battery chargerġ.1.2.1 Charge voltage (13.8V no battery connected) 1.1.2.2 Charge rate (Check recovery rate of charger)ġ.1.3 Check duty cycle of system (battery capacity sufficient) 1.1.4 Check condition of battery leads and connectors.ġ.2 Multiple collision condition (Status flashing 4 times)ġ.2.1 Adjust collision sensitivity (high to medium or to low) 1.2.2 Check for something physically obstructing the movement of gateġ.2.2.1 Rack pressing down onto pinion 1.2.2.2 Bad rack joints 1.2.2.3 Seized or badly running wheels 1.2.2.4 Top guide rollers restricting the gate 1.2.2.5 Dirt on rail 1.2.2.6 Physical damage to the rail 1.2.2.7 Wheel catching side of pinion 1.2.2.8 Gate hitting endstopġ.2.3.1 Dirt inside the DOSS 1.2.3.2 Poor connection between the DOSS and the controller (check cable and connector) 1.2.3.3 Doss cable fitted back to front 1.2.3.4 Doss not being driven due to missing coupling or faulty bevel drive. THE CARD IS NOW PROGRAMMED TO DEFAULT SETTINGS AS SHOWN IN REMOVE THE " SET" LINK AND DISCONNECT " PED" AND " FRX" FROM " COM".ħ. REMOVE THE POWER (BATTERY AND POWER SUPPLY).Ħ. REMOVE POWER (POWER SUPPLY AND BATTERY IF D3 or D5).Ĥ. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
January 2023
Categories |